Caution: This documentation is for eZ Publish legacy, from version 3.x to 5.x.
For 5.x documentation covering Platform see eZ Documentation Center, for difference between legacy and Platform see 5.x Architecture overview.

Adding custom watermarks

The eZ Image Editor comes with a list of pre-populated watermarks. However, the system also supports adding custom watermarks to the existing set.

Follow the steps below to add watermarks:

  • Place your watermark file (usually a PNG) in a 'watermark' subfolder of an 'images' design folder like shown here:

  • Add the new watermark file to the list of used watermarks in image.ini (extension/mydesign/settings/image.ini.append.php)

  • Clear your caches. This is done from the "Administration Interface". In the "Setup" tab, click on the "Cache Management" link in the menu on the left.

The custom file will be visible in the list of watermarks that is presented when you use the watermarks function in eZ Image Editor.

Geir Arne Waaler (19/04/2010 10:31 am)

Geir Arne Waaler (21/04/2010 9:13 am)

Geir Arne Waaler, Ester Heylen


There are no comments.