Path

ez.no / documentation / ez publish / technical manual / 4.x / installation / manual installation / manual installation on windows


Caution: This documentation is for eZ Publish legacy, from version 3.x to 5.x.
For 5.x documentation covering Platform see eZ Documentation Center, for difference between legacy and Platform see 5.x Architecture overview.

Manual installation on Windows

This part of the 4.x documentation is for eZ Publish 4.0, only reference section is common for all eZ Publish 4.x versions as well as eZ Publish 5.x "LegacyStack", please select the version you are using for the most up to date documentation!

The requirements for doing a manual installation must be met. Please read the previous section if you're not sure about the requirements. Proceed only if you have access to a Windows based system with Apache, PHP, MySQL or PostgreSQL already installed and running. As mentioned earlier, the database server may run on a different computer than the web server. A manual installation consists of the following steps:

  •  Setting up a MySQL database
  •  Downloading eZ Publish
  •  Unpacking eZ Publish
  •  Manual configuration of eZ Publish

The only difference between a normal and a manual installation is the last step. Instead of running the web based setup wizard, eZ Publish is manually configured by editing a couple of files. The first three steps are explained under the "Installing eZ Publish on Windows" section. The last step is explained under the "Manual configuration of eZ Publish" section.

Balazs Halasy (03/05/2005 8:26 am)

Ricardo Correia (17/04/2013 9:51 am)

Balazs Halasy, Svitlana Shatokhina, Geir Arne Waaler, Ricardo Correia


Comments

There are no comments.